Question Processor Running but Display, Mouse and Keyboard not working

[bala_4370]

Dear All,

My system suddenly did not show anything in monitor and Mouse, Keyboard as well did not work, but the Processor is running. I did all basic troubleshooting like removing and fitting the RAM, removing the CMOS battery and putting it back - Nothing worked.

Later I replaced the CMOS battery with a new one and now it is booting into BIOS setting, I changed the Date and time and when I click on Save and Exit, it goes blank again and the monitor, mouse and keyboard dont work.

Again if I remove the battery and fit it again, the same thing happens.

Please help.

Santhosh.

 

[rgd1101]

full system spec? include brand and model of the psu

 

[statistx]

Dear All,

My system suddenly did not show anything in monitor and Mouse, Keyboard as well did not work, but the Processor is running. I did all basic troubleshooting like removing and fitting the RAM, removing the CMOS battery and putting it back - Nothing worked.

Later I replaced the CMOS battery with a new one and now it is booting into BIOS setting, I changed the Date and time and when I click on Save and Exit, it goes blank again and the monitor, mouse and keyboard dont work.

Again if I remove the battery and fit it again, the same thing happens.

Please help.

Santhosh.

I thought this was my thread, cause i have the same issue.
Not sure if it helps for you, guess since you removed the CMOS you already did that, but USUALLY it works if I unplug everything including power, then wait for a good 10-20 minutes, plug everything back in and boot again.
Not sure what it is, I am now replacing my MOBO, cause that seems to be the most likely culprit, but you can go here and see if anything from my thread helps: https://forums.tomshardware.com/thr...en-suddenly-the-issue-is-there-again.3743922/

 

[bala_4370]

full system spec? include brand and model of the psu

ASUS Prime B350M-K Board
Ryzen 1300X Processor
16 Gigs Corsair Vengeance RAM
1050 TI 4 GB Graphics Card
1TB HHD
512 GB SSD
PSU - Antec VP550P

 

[bala_4370]

I thought this was my thread, cause i have the same issue.
Not sure if it helps for you, guess since you removed the CMOS you already did that, but USUALLY it works if I unplug everything including power, then wait for a good 10-20 minutes, plug everything back in and boot again.
Not sure what it is, I am now replacing my MOBO, cause that seems to be the most likely culprit, but you can go here and see if anything from my thread helps: https://forums.tomshardware.com/thr...en-suddenly-the-issue-is-there-again.3743922/

Thanks, will try disconnecting all cables, powercord etc and try again. But I need a solution as I do not have money to buy new components 🙁