After reloading PC almost every time recommended to set RAID mode. I tried to do so. I used EZ tuning wizard to enable RAID mode. But it stuck in the process. So the tick is displayed in front of "Enable RAID mode", then I choose Port SATA, It gives me my SSD as available disk but on this step the NEXT button is not active, I can go back to PORT selection or cancel RAID configuration. Everything else is not accessible. Boot device is not found.
When I restarting PC, RAID configuration appears on the same step, so I cannot roll it back or continue because of inactive NEXT button.
Is it possible to somehow finish RAID set up or cancel it completely so I can boot?
When I restarting PC, RAID configuration appears on the same step, so I cannot roll it back or continue because of inactive NEXT button.
Is it possible to somehow finish RAID set up or cancel it completely so I can boot?