Just finished my first build and loving it so far. I ran into what I think might be a problem. I have a GIGABYTE GA-Z77X-UD5H LGA 1155 Intel Z77 Intel Motherboard with RAM G.SKILL Ripjaws X Series 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 1600 .
I went into the BIOS to M.I.T, Current Status and my frequency looked correct at 1600, but both the Memory Channel A & B had timings of tCL 11, tRCD 11, tRD 11 and tRAS 28 when I believe they should be tCL 9, tRCD 9, tRD 9 and tRAS 24. I doubled check and went in to M.I.T., Advance Memory Setting and under both Channel A & B Timing Settings I found the above settings of 11-11-11-28 as well.
If this is something that should be corrected, could you please tell me how to correct it as well. I change the setting for Advance Memory Setting from AUTO to both QUICK and EXPERT and was unable to figure how to change the timing to 9-9-9-24.
Thank you in advance for your help.
I went into the BIOS to M.I.T, Current Status and my frequency looked correct at 1600, but both the Memory Channel A & B had timings of tCL 11, tRCD 11, tRD 11 and tRAS 28 when I believe they should be tCL 9, tRCD 9, tRD 9 and tRAS 24. I doubled check and went in to M.I.T., Advance Memory Setting and under both Channel A & B Timing Settings I found the above settings of 11-11-11-28 as well.
If this is something that should be corrected, could you please tell me how to correct it as well. I change the setting for Advance Memory Setting from AUTO to both QUICK and EXPERT and was unable to figure how to change the timing to 9-9-9-24.
Thank you in advance for your help.
Facebook
Twitter
Instagram