Question Reverting back to built in Graphics

[kevdan32]

Hello

I recently purchased a new graphics Card (AMD Radeon RX550) for my Dell Optiplex 7020 (SFF). I believe it is not right for my PC after installing it.

I have tried to remove it by disabling the driver/ uninstalling etc?and physically removing) however when I reboot the computer and plug the HDMI cable back into the inbuilt Card (Intel HD 4660) but i don't get any feed on my monitor. Its like its gone from the system.

Can someone please tell me how I can revert back to the internal graphics card.

Thanks in advance

Kevin

 

[williamjeremiah]

Hello Kevin,
Try clearing the mainboard's cmos. That will revert it back to factory settings.
Here's a video explaining the procedure:

View: https://youtu.be/keLDvMAd2JE

 

[williamjeremiah]

You might try unplugging the PC and holding the power button in for about ten seconds, first. Without clearing the cmos.
Then power it up and see if it switches back.
If it doesn't, then you can clear the cmos.

 

[kevdan32]

You might try unplugging the PC and holding the power button in for about ten seconds, first. Without clearing the cmos.
Then power it up and see if it switches back.
If it doesn't, then you can clear the cmos.

Should I do this with the graphics card out of the machine. Thanks

 

[logainofhades]

Why do you believe it isn't right for your system?

 

[williamjeremiah]

Yes. I assume you've already taken the graphics card out. Yes, leave it out.
There may be a 2nd option to try before clearing the cmos..
If you've ever accessed your bios/uefi settings before, there may be an option in there to specifically tell it whether to run integrated graphics or from a card on the PCIe slot. Modern boards generally have an auto detection for this, but since yours didn't auto-negotiate, then maybe a reset is needed.
However, if you've accessed the board's settings before, you could have a look-see.

 

[kevdan32]

Why do you believe it isn't right for your system?

It’s not displaying right on some things and I think the power draw on the 255w psi is too high I may be totally wrong and have not installed it correctly. Novice here

 

[williamjeremiah]

think the power draw on the 255w psi is too high

Maximum power draw is 50 watts. The suggested PSU is 250w minimum.
https://www.techpowerup.com/gpu-specs/radeon-rx-550.c2947

 

[williamjeremiah]

Did you use the AMD Adrenaline driver ?
https://www.amd.com/en/products/software/adrenalin.html