[SOLVED] [Solved] Didn't start assembly (Aorus 360 M Pro + i7 9700 + KVR32N22D8/16)

[JaegerX]

On Input:

1. Aorus 360 M Pro (rev 1.0, bios ver is unknown), (as MB)
2. Core i7 9700. (as i7)
3. Kingston 16 Gb (KVR32N22D8/16) (as Mem)
4. Video on board.

On output:

System starting, quick single blink CPU led on MB, after that switch on led DRAM on MB - led is continuously light. Speaker didnt beep's, no post screen. System reboot automaticly after 3 sec approximatly, after restarts all steps repeating except reboot.

Made :

Change slots of mememory: state is unchanged;

I suppose, that bios is old and don't understant memory or CPU, but why there is no POST screen.

Please help to diagnose (complex conditions for grade A+: you havn't another memory bank, you havn't another gen 8 or gen 9 CPU and you havn't anther working system with comparable components).

 

[PC Tailor]

Welcome to the forums my friend!

Did you ensure that the BIOS was updated prior to installing the CPU?
that board requires BIOS F2 to take the 9700. If it is BIOS F1 then it will not boot.

 

[JaegerX]

Welcome to the forums my friend!

Great greetings.

Did you ensure that the BIOS was updated prior to installing the CPU?

No, I havn't tools to do that.

 

[PC Tailor]

Well if the board is running BIOS F1, then it will not boot until you update the BIOS.
This can only be done with an out of the box compatible CPU.

 

[JaegerX]

This can only be done with an out of the box compatible CPU.

Thanks. I'll try it.

 

[Calvin7]

The memory is programmed to JEDEC standard latency DDR4-3200 timing of 22-22-22 at 1.2V.

Motherboard has Support for DDR4 2666/2400/2133 MHz memory modules.

3200MHz is too fast for the motherboard.
https://www.kingston.com/dataSheets/KVR32N22D8_16.pdf

It does not appear the memory operates at anything under 3200MHz which is not a supported speed. Try using DDR4 2666/2400/2133 MHz memory modules.

 

[JaegerX]

Trouble is solved by replacing memory with slow memory bank.

The reason best explained by

The memory is programmed to JEDEC standard latency DDR4-3200 timing of 22-22-22 at 1.2V.

Motherboard has Support for DDR4 2666/2400/2133 MHz memory modules.

3200MHz is too fast for the motherboard.
https://www.kingston.com/dataSheets/KVR32N22D8_16.pdf

It does not appear the memory operates at anything under 3200MHz which is not a supported speed. Try using DDR4 2666/2400/2133 MHz memory modules.

 

[PC Tailor]

You can select his best answer by clicking the trophy in the corner of the post