Recent content by Mahbub1

So My desktop which has a Ryzen 5 5600x + 3070ti uses roughly 80 to 90 watts during idle and peaks to 130 to 160 watts sometimes when I open Chrome and do stuff (monitor power consumption included). To reduce some power consumption I thought to use the laptop and connected it to the monitor for...

I have an NH U9s cooling a Ryzen 5 5600X on a Gigabyte Aorus B550I. With the default installation kit, I can only mount the cooler in horizontal mode. I searched and found that I have to get the NM-AM4-UxS kit to mount U9s in vertical mode. I searched images to find that the two small brackets...

Ok so i have i7 9700k (not overclocked) being cooled by noctua nh u12s in push pull.. when i set voltage in bios to auto and run prime 95 tests. Without avx. temps go to like 90 and i checked the voltage being used by cpu in hwinfo.. it shows a max voltage of 1.224 ... But when i go into bios...

Okk thanks.. i will set a -0.070v

ok so i have a 9700k and i set a negetive offset of -0.070v and it gave me better temps.. but when i digged the internet someone told that setting a negetive offset helps temps but it worsens the "cpu transition voltage" which can degrade cpu in long run.. i have no idea what "cpu transition...

i want to buy this cooler, but my issue is in the manual, on the second page it shows that the mounting bracket has three holes, the middle hole is meant to be used for mounting lga 1151, whilst in the install page, the diagram shows the outer holes used for screwing the cooler retention...

I have Asus AC58U and in the specification section under MIMO subheading it says MIMO technology 2.4 GHz 2 x 2 5 GHz 2 x 2 Does this mean it can put out 4 simultaneous data streams (two 2.5ghz and two 5ghz) at once, or this means it can put out two simultaneous data streams at once (two...

OK, so this question might sound funny, but it's not. I have a laptop setup. The router is connected to the laptop by ethernet cable under the table and the wire is a mess, it is making my OCD go crazy. I am thinking of going wireless. I sit for long hours, but what's making me afraid of going...

just internet thats it

i looked at two routers, one is asus rt ac 53 which has 64mb ram and has mimo support, 1 5ghz and 2 2.4ghz. another i looked at is 128mb ram and says 2*2 mimo. my question is does 2*2 mimo mean router can send simultaneous 4 devices or 2 devices? if it means 2 devices then whats the use...

i have a internet connection of 100mbps, now the 8265 card on 5g can take 867mbps, and 3168 on 5g can take 300 mbps, i wanna ask in my use case, which is a 100mbps internet, would the 8265 give any benefit over a 3168?

So my ISP provides me 100 mbps speed. I bought the Asus AC58U (4 antennae, 1300mbps), later discoverd that there is a cheaper Asus AC53U with 2 antennae and upto 1200mbps, and has same flash and ram memory and the same amount of MIMO as the 58U, so the only advantage i have is 100mbos more speed...

i bought a third party battery for my hp x360 (k107tu), and in the hp assistant it is showing uncalibrated, and it says if its not calibrated battery needs to be replaced, the battery is running tho. so like do i really need to replace battery if the hp assistant says it needs to be replaced if...

Bnow m getting.. actually i was setting up second router as range extebder.. then i reset n setup router as access point...i did that now getting full 70mbps up n 50mbps down

i have two choices, asus ac53u (128mb flash, 128mb ram) or asus ac53 (8mb flash, 64 mb ram), both routers have mimo and i need to connect two devices wirelessly. now the ac53 is cheaper but the less ram and so much less flash compared to the 53u is making me afraid. so i want to ask do flash...