HI, i just bought my ab9pro and set it up. Initially i got the checksum error (which apparently is well known) for this mb. Got thru that, then came the 2A POST error. I read that clearing the CMOS helps, so I did, my computer would boot but whenever i change anothing in cmos, the 2A error comes back.
Then I read somewhere that taking out the battery and clearing the CMOS would help. So i took out the batter and cleared CMOS. Right after that now I'm getting a POST error code 7F. The sequence goes to 75 then gets the stuck at 7F with nothing on the monitor screen. It's blank. I tried pressing F1 then the computer boots for a bit and gets stuck at FF. Cleared CMOS again and restarted, and gets stuck at 7F again. The screen won't even post. It's just blank.
What's going on?!?! Please help
my rig
E6300
Abit AB9Pro
Kingston value ram 2x1gb 667Mhz
Evga 8800GTS 640mb
WD 250KS
Cooler Master Real Power 550W
Then I read somewhere that taking out the battery and clearing the CMOS would help. So i took out the batter and cleared CMOS. Right after that now I'm getting a POST error code 7F. The sequence goes to 75 then gets the stuck at 7F with nothing on the monitor screen. It's blank. I tried pressing F1 then the computer boots for a bit and gets stuck at FF. Cleared CMOS again and restarted, and gets stuck at 7F again. The screen won't even post. It's just blank.
What's going on?!?! Please help
my rig
E6300
Abit AB9Pro
Kingston value ram 2x1gb 667Mhz
Evga 8800GTS 640mb
WD 250KS
Cooler Master Real Power 550W