- Apr 6, 2005
- 8
- 0
- 18,510
I just got a barebones system from Mwave.com. It has an Abit NF8 w/ an A64 3000+ and 1 gig of "mwave" memory already installed in an Antec slk1650 case.
I just added my CD drive, a hard drive and video card but all I get when I boot up is one long beep every 5 seconds. The LEDs on the keyboard light up but I get nothing on the monitor. I have
1) replaced the RAM w/ RAM that works in another system.
2) replaced the video card w/ w videocard that works in another system.
3) cleared the bios.
All I get is the same beep...even when I tried booting w/ out any RAM at all.
The folks at Mwave seemed to have connected all of the case jumpers correctly but other than clearing the CMOS, I have done no actual work w/ motherboard conncections or jumper settings....outside of connecting my drives. I haven't been able to find much luck in the instruction manual.
Any ideas? Thanks a lot in advance.
-Blake
I just added my CD drive, a hard drive and video card but all I get when I boot up is one long beep every 5 seconds. The LEDs on the keyboard light up but I get nothing on the monitor. I have
1) replaced the RAM w/ RAM that works in another system.
2) replaced the video card w/ w videocard that works in another system.
3) cleared the bios.
All I get is the same beep...even when I tried booting w/ out any RAM at all.
The folks at Mwave seemed to have connected all of the case jumpers correctly but other than clearing the CMOS, I have done no actual work w/ motherboard conncections or jumper settings....outside of connecting my drives. I haven't been able to find much luck in the instruction manual.
Any ideas? Thanks a lot in advance.
-Blake
,then take out battery,turn on pc, turn off,place back battery and done 
Facebook
Twitter
Instagram