Archived from groups: microsoft.public.windowsxp.hardware (
More info?)
Not a problem. Did all of the devices get recognized?
----
Nathan McNulty
John Moncrief wrote:
> Thanks again.>-----Original Message-----
>
>>OK, it sounds to me like you have an Intel chipset
>
> motherboard with
>
>>integrated Intel graphics. You may want to install these
>
> drivers as
>
>>listed below:
>>
>>Chipset drivers:
>>ftp://aiedownload.intel.com/df-
>
> support/7484/eng/infinst_enu.exe
>
>>Video drivers:
>>ftp://aiedownload.intel.com/df-
>
> support/4665/eng/win2k_xpe67.exe
>
>>Finally, you may want to grab Everest Home from
>
> www.lavalys.com to find
>
>>out what other hardware you have if you continue to have
>
> Unknown Devices
>
>>after installing the above drivers. This program will
>
> not only tell you
>
>>all the hardware in your computer, but it will also
>
> provide a link to
>
>>the drivers
😉
>>
>>----
>>Nathan McNulty
>>
>>
>>John Moncrief wrote:
>>
>>>Thanks for answering. I have an Inter9r) 82810
>
> graphics
>
>>>controller. Is that it? I notice that on the system
>>>information report, the "problem devices" are Inter(r)
>
> AIM
>
>>>EXtern Flat Panel Driver 5, 6 and 7 and the Inter (r)
>
> AIM
>
>>>External TV Encoder Driver 5. The message for each is
>
> to
>
>>>install the driver. In the Device Manager, under the
>>>category of "unknown" are the four "drivers".
>>>
>>>
>>>>-----Original Message-----
>>>>What video card are you using? I would reinstall all
>>>
>>>system drivers if
>>>
>>>
>>>>possible (meaning your motherboard drivers, PCI Card
>>>
>>>drivers, and video
>>>
>>>
>>>>card drivers).
>>>>
>>>>----
>>>>Nathan McNulty
>>>>
>>>>
>>>>John Moncrief wrote:
>>>>
>>>>
>>>>>I installed Service Pack 2. It slowed my machine so
>>>
>>>badly
>>>
>>>
>>>>>that I had to uninstall. Since then the Microsoft
>>>>>Hardware Installer Wizard keeps appearing. It seeks
>>>
>>>the
>>>
>>>
>>>>>driver for "Intel (AIM) External Flat Panel Driver."
>
> I
>
>>>>>have a Samsung SyncMaster 171s flat panel monitor. I
>>>>>reinstalled its driver after uninstalling Service Pack
>>>
>>>2.
>>>
>>>
>>>>>When the Hardware Installer Wizard searched for the
>>>
>>>driver
>>>
>>>
>>>>>on the SyncMaster CD, it did not find what it was
>>>
>>>looking
>>>
>>>
>>>>>for. When it searches my hard drive it just keeps
>>>
>>>going.
>>>
>>>
>>>>>Any suggestions?
>>>>
>>>>.
>>>>
>>
>>.
>>