New PC seems to running fine but can't get a signal from the monitor

[Siouxperman]

I recently finished building my new gaming rig. When I powered it up for the first time everything seemed to be tuning fine and I got a CPU temp reading on my mobo led display. I then hook my pc to my new monitor via dp cable and I got a no signal screen. Tried connecting the monitor to both the graphics card and the mobo (with and with out the graphics card hooked up) but still got nothing.
I've breadboards, rearranged ram, and clears cmos... and nothing has worked

My build is as follows
I5-7600k CPU
Msi Z170a gaming m7 mobo
16gb (2x8gb) gskill tridentZ ram
EVGA 750 bronze psi
Msi GTX 1060 6gb

 

[terry4536]

Do you have access to another monitor? I would guess at this point that it is a cabling or monitor problem. Also you can test the monitor on another system.

You can also try using a HDMI cable to a HDTV (to verify that the PC is working).

 

[terry4536]

With the graphics card removed the motherboard video outputs should work. The BIOS video output is defaulted to auto. So without a graphics card the motherboard video outputs are the default video output.

(Some motherboards do not support integrated graphics.)

 

[terry4536]

The processor is compatible with that motherboard. I can't determine memory compatibility from your list.

 

[terry4536]

Some monitors do require a display port cable to operate (144Hz or 3D monitors for example). So you can try different or upgraded monitor cables.

Have you tried resetting the monitor? Have you tried the monitor troubleshooting steps?

 

[Siouxperman]

I've tried a hdmi connection to a tv with no luck. Haven't tried any monitor troubleshooting steps

 

[terry4536]

Then it is most likely a PC issue. Do you have any red troubleshooting LED's on the motherboard ? Is there a LED error display on the motherboard? If not do you have access to a case speaker?

Here are two troubleshooting checklists.

http://www.tomshardware.com/faq/id-1893016/post-system-boot-video-output-troubleshooting-checklist.html

http://www.tomshardware.com/faq/id-2041564/troubleshoot-boot-display-issue.html

Here are some bread-boarding guides? (you mentioned that you have tried this already.)

http://www.tomshardware.com/faq/id-2176482/breadboarding-stripping-basics-troubleshooting.html

http://www.tomshardware.com/forum/262730-31-breadboarding

http://www.tomshardware.com/faq/id-1753671/bench-troubleshooting.html

There are three major components that can give this result. Those are the motherboard, processor and memory. Without any error messages, LEDs, or beep codes, it is going to be difficult to troubleshoot.

How long do you have left on returning your components?

Here is a case speaker if you can't find one locally.

http://www.newegg.com/Product/Product.aspx?Item=N82E16812201032&cm_re=case_speaker-_-12-201-032-_-Product

 

[Siouxperman]

mobo has troubleshooting LED, shows 19 which is early south bridge initialization, according to the user guide

 

[terry4536]

Then the motherboard will have to be replaced. Depending upon where you purchased it from, you have up to 30 days to return it.

The one possibility is to reload the motherboard drivers. I doubt re-flashing the BIOS will help but you can try that as well. (I'm not sure that either can be done with this motherboard.)