noobatpcbuilding
Honorable
Motopsychojdn :
Leave the Psu as it is, peel the label off instead,
Sleeve the cables or wrap in fabric tape,
http://www.ebay.co.uk/itm/Wiring-Loom-Harness-Adhesive-Cloth-Fabric-tape-19mm-25m-/180637405593?pt=UK_In_Car_Technology&hash=item2a0ed41199
Hint, duct tape will hold sharp bends inplace, then dress with the above to look neat
you could also route the fan wire slightly differently, have it come through the back of the I/o shield closer to the socket,
make/buy a molex extension for the Hdd and optic to allow more reach,
Seeing as your Hdd is mounted differently anyhow, why not stick it on top of the optic drive and tuck wires away,
and nudging the Hs should be fine, just don't make a habit of it 😛
That should keep you busy hehe
Moto
Sleeve the cables or wrap in fabric tape,
http://www.ebay.co.uk/itm/Wiring-Loom-Harness-Adhesive-Cloth-Fabric-tape-19mm-25m-/180637405593?pt=UK_In_Car_Technology&hash=item2a0ed41199
Hint, duct tape will hold sharp bends inplace, then dress with the above to look neat
you could also route the fan wire slightly differently, have it come through the back of the I/o shield closer to the socket,
make/buy a molex extension for the Hdd and optic to allow more reach,
Seeing as your Hdd is mounted differently anyhow, why not stick it on top of the optic drive and tuck wires away,
and nudging the Hs should be fine, just don't make a habit of it 😛
That should keep you busy hehe
Moto
Alrighty..thx for the tips 😀