CPU-Fan on KT3 Ulra2

[Guest]

Archived from groups: alt.comp.periphs.mainboard.msi-microstar (More info?)

Hi,

I changed my heatsink to a low noise one. This is runnimg between 1400
and 2400 rpm. When booting a messsage says there is no fan running,
shutdown or continue. I disabled Fancontrol in BIOS, but i'd like to
install a propper one. What lowest rpm is correct?
When warm booting the System this takes about 30 sec. During this time
D-bracket show led1=green, leds 2-4 red. Initializing chipset. Cold boot
doesn't do so and runs fine. Hints?

Regards

--
Gruß
Manfred

 

[Guest]

Archived from groups: alt.comp.periphs.mainboard.msi-microstar (More info?)

Manfred Bathen wrote:
> Hi,
>
> I changed my heatsink to a low noise one. This is runnimg between 1400
> and 2400 rpm. When booting a messsage says there is no fan running,
> shutdown or continue. I disabled Fancontrol in BIOS, but i'd like to
> install a propper one. What lowest rpm is correct?
> When warm booting the System this takes about 30 sec. During this time
> D-bracket show led1=green, leds 2-4 red. Initializing chipset. Cold
> boot doesn't do so and runs fine. Hints?
>
> Regards

Go into the bios in the hardware health section, or whatever it's called.
Turn off the CPU fan warning listing. You will see it.

 

[Guest]

Archived from groups: alt.comp.periphs.mainboard.msi-microstar (More info?)

On Tue, 13 Apr 2004 20:39:27 +0200, Manfred Bathen wrote:

>I changed my heatsink to a low noise one. This is runnimg between 1400
>and 2400 rpm. When booting a messsage says there is no fan running,
>shutdown or continue. I disabled Fancontrol in BIOS, but i'd like to
>install a propper one. What lowest rpm is correct?

Either SiSoft Sandra or Motherboard Monitor will tell you all you
need about the fans rpm, and the temps too...