Hello ! I like electronics and I started to try and buy faulty mobos to fix them.
Setup :
2 Asus Pro Gamer Motherboards
I7-4790k
8 GB of Ballistix Ram
Pure Rock 2 heatsink and fan
All this on a silicone mat, out of the case.
What happened :
I had an old GPU that i used to test mobos with, so i tried starting my first B85 with it, with a full setup as described and it instantly goes into a boot loop. All fans start for a fraction of a second then stop to an almost stop, then again and again.
I try and hook up my second B85, without my GPU, with only the strict minimum, and it starts. I kill it, install the GPU, then boot loop.
What I tried :
All components appart for the motherboard have been tested and known to work.
I tried basic manipulations like BIOS reset, different stick of RAM, removed and reinstalled everything twice.
I tried to mesure stuff with a multi-meter but i really didn't find anything relevant, probably due to my lack of knowledge.
Could you guide me through testing procedures ? I have a solder station and i intend to fix it even if it costs me, they were cheap those mobos so if i fail i will have trained.
Setup :
2 Asus Pro Gamer Motherboards
I7-4790k
8 GB of Ballistix Ram
Pure Rock 2 heatsink and fan
All this on a silicone mat, out of the case.
What happened :
I had an old GPU that i used to test mobos with, so i tried starting my first B85 with it, with a full setup as described and it instantly goes into a boot loop. All fans start for a fraction of a second then stop to an almost stop, then again and again.
I try and hook up my second B85, without my GPU, with only the strict minimum, and it starts. I kill it, install the GPU, then boot loop.
What I tried :
All components appart for the motherboard have been tested and known to work.
I tried basic manipulations like BIOS reset, different stick of RAM, removed and reinstalled everything twice.
I tried to mesure stuff with a multi-meter but i really didn't find anything relevant, probably due to my lack of knowledge.
Could you guide me through testing procedures ? I have a solder station and i intend to fix it even if it costs me, they were cheap those mobos so if i fail i will have trained.