DRAM

Hello guys, I recently upgraded my PC to 32 GB RAM, I had 2x8 TridentZ 3600 MHz and I sell it and bought a 4x8 Corsair vengeance pro RGB and since I installed corsair ram when I turn off my pc for an hour or more, when I try to turn it on the yellow light stays on and nothing showing on the...

Hello, recently I bought Ryzen 9 5950x for my workstation that has 4 sticks of ram - 48gb (2x8+2x16) HyperX 3200mhz with xmp1 enabled, on MSI Tomahawk Max B450. Sometimes under load I had sudden black screen and CPU debug led. I knew that 5950x is too much for b450 and I thought that was the...

I got my first PC a couple months ago and have had no problems up until now. I loaded everything up as I normally do, began to play and all of a sudden after 10 or so minutes the whole thing shut off (fans still going) and then the dreaded 3 beeps sounded and now DRAM LED is showing on my...

Today i got a new mobo for my pc, since my old one died. I got it, installed it into my system and after powering it on,surprise, the DRAM debug led was on. What i tryed: - try only a stick of ram and both swapped, in the correct spots -reseting the bios -removing and adding the cpu back into...

Hi, I have a MSI B450 Tomahawk Max and 2 8gb sticks of eam group Vulcan Z T-Force. My brother recently swapped our RAM as he wanted to test the differences and when I reinstalled my memory, everything lights up and powers on except for the fact that the DRAM LED stays lit and I can’t get onto...

Build new pc spec are 12400f Asus b660m plus d4 Tridentz F4-3200C16D-16GTZR nzxt h510 flow Pc runs perfectly fine while using everything auto in bios dram configuration but as soon as I set xmp 1/2 system doesn't start and bios gets reset tried 3600mhz tried 3200mhz with 1.4v same problem but...

After trying to overclock (as far as i remember i changed voltage on DRAM, but not sure since it was a month ago or so) I've got this error and nothing helps. Tried flashing bios from usb-drive,but it flashes green 3-4 times, than flashes stops and it stays in lit state afterwards(once i left it...

Hello All, Been one heck of a couple weeks. I was plagued with a system crash and on reboot I was greeted with the orange DRAM light on the MB. I did some basic trouble shooting, trying single ram sticks in every slot combination, went and bought a new ram kit from Best Buy and still the same...

I've been using a single RAM Kingston Hyperx DD4 8Gb 2133MHz and decided to add a new one, exact same one but diferent model number, same speed and size. Old model number: HX421C14FB2/8 New one: HX421C14FB/8 I searched for a while and apparently the model ended 2/8 supports dual channel and the...

parts: Asrock b550m pro4 Ryzen 5 3600 with stock cooler team tforce 8gb 3200 x2 super flower leadex III gold 650w I also have an additional evga 500w 80plus power supply and gtx 1050 for testing. (i do not want to use the graphics card that was in it for troubleshooting). Problem: I...

So, i've just built my PC and i'm facing a few issues. The PC boots from a 120gb Kingston SSD (windows drive) but i've also got a WD 1TB drive and a 1TB KINGSTON A2000 installed. The CPU is an i5 11600K The RAM is 2x8 KINGSTON FURY Renegade Black, DDR4 3200MHz The PSU is a new Antec HCG750...

Will these DRAM Modules "G.Skill RipJaws V Series 16GB (2 x 8GB) 288-Pin SDRAM PC4-28800 DDR4 3600 CL18-22-22-42 1.35V Dual Channel Desktop Memory Model F4-3600C18D-16GVK" work on this motherboard GA-Z270 Gaming K3 (rev.1)?

Computer was running perfectly fine. Turned it off one day when I went to bed, woke up the next day and it wouldn't post. DRAM light showing on motherboard. I assumed it was either CPU or Ram issue with seating so I reseated both and made sure no bent/missing/dirty pins on CPU. Also reseated all...

Hi guys, 1) I'm pretty new on this website and also this is my first time building my own PC. I came across the terms DRAM and DSRAM while deciding which RAM I should buy. I would appreciate it if someone can tell me the difference between these two terms. 2) I would also want to ask advice...

When i go to boot my PC (rtx 2070, ryzen 7 2700x, asus b450-f, 16gb trident Z neo ram) a white light turn on the Mobo and i cant get a post. This problem started out of nowhere and I cant seem to find the root of the issue. After dusting my pc and fiddling with the CPU cooler it booted again but...

I turned my computer on this morning having last used it last night with no issue to find that it would not boot, It would turn on with the LED lights and fans turning on but nothing beyond that my screen remained black. I decided to search this up originally not noticing the DRAM light and...

I recently purchased a used msi 2060 ventus oc from a local and it was working fine for the first day, nothing wrong was happening clocks were stock, no crashes. I go and shut down my pc to sleep for the night then, the next morning I turn it on it has the cpu and dram leds blinking. I reset the...

System information: MB: ASUS ROG STRIX X570-E GAMING CPU: AMD Ryzen 7 5800X RAM: Corsair DDR4 Vengeance RGB Pro 2x16GB 3200MHz GPU: MSI Radeon RX 570 HDD: Western Digital Black 1TB, Western Digital Black 2TB, Western Digital Red 3TB SSD: Samsung 970 EVO NVME M.2 1TB New additions: HDD...

Hi guys, the timing will be tight soon. But, I wonder why the speed of DRAM in both CPUz and AIDA 64 show about 3466 when I set in BIOS 3600 also task manager shows it running at 3600? How can I fix it?

I built my computer almost 8 months ago. While my pc is running, and usually while i am browsing through the web or my files, i will hear a single "beep" from the case, two or three or more times with at least a minute in beetwen. If i restart my pc, most likely i will not hear any more beeps...

Specs: MB: MSI B150M PRO-VDH (MS-7982) CPU: Intel Core i7 6700 GP: AMD Radeon R9 380 Series 2GB RAM: 2 BALLISTIX SPORT, DDR4 , 8GB, 2400MHz, 1.2V Hello everyone! So I turned on my pc and the screen said "no signal" and the EZ Debug Led was switching between DRAM and CPU. My rams were placed...

It happened that I am overclocking my RAM through XMP profile by auto with the exception of selecting 3200mhz (2666mhz hyperx kingston). It usually set itself around 1.36v based on CPUz and HWMonitor but i accidentally left it by 1.2v manual since I was playing around it the other day. I find...

Hello! I just recently bought off eBay a fairly cheap MSI A320M PRO-VH that's been kept in good condition. I had a leftover Ryzen 3 2200g lying around with its stock heatsink and thought why not give it a home. I tried to breadboard with it and noticed the CPU debug light is on. Turns out the...

Ok so I just built my PC (I'll list part details down below), but after putting everything together and plugging everything where it should be I run into an issue. I'll start with what works, my fans run perfectly fine (GPU fan runs too), so I'm guessing that's no issue with my motherboard, GPU...

So Ive just changed my cpu, psu, and motherboard because some of my components were broken from my old pc. After putting them all on again my pc booted and I managed to use it for an hour, after which it suddenly turns off by itself. After trying turning it on again it failed to boot, giving a...

My Memok light is red and my pc is failing to display anything on my monitors. This problem started around a week ago and it was when i was installing a new cpu and i had taken out the ram to have more room, i put them back in the right place but since then this problem has been constantly...

I recently RMA my motherboard because of an issue I was having (it was a gigabyte aurous x570 elite) I got a new motherboard (gigabyte aurous b550 pro) and with this motherboard came its own problem. I plugged everything in and everything turns on, AIO, fans, etc. except the troubleshooting leds...

I just built my little brother a new PC, only one RAM stick will light up and then when I turn it on, it will run fine then the screen will go black and the DRAM light will come on and then the PC does a weird pulse where all the fans have a little stutter then run for 2 seconds then pulse then...

Hello Folks, I was just puting together my temporary computer until all the parts arrived. System: Lets start with the components: Processor: Ryzen 9 5950 x Motherboard: Asus rog strix x570-i gaming GPU: RTX 2080 (from my old build for now) ram: 2x corsair vengeance led 2x 8gb 3000 (for now)...

hey, I've just built myself a new pc and I'm currently getting a yellow light for dram on startup. the CPU light is green and I'm getting a startup screen asking me to press f2/del for bios in which my if I press the screen won't change. i thought it might of been the ram not being compatible...

'Eyo guys, I'm encountering a big problem with an ASUS TUF FX504GM. Basically, I've upgraded my RAM on this laptop, and I have to set the DRAM and Frequency. Normally I would do that via the BIOS or UEFI in this case, however there is no XMP, DRAM Settings or AI Tweaker options under the...

So I just assembled a new PC today and cannot for the life of me figure out what’s going on. Half the time it get stuck at the “press del to enter bios” screen and it won’t do anything. The other half of the time when I boot it tells me no display port found and the monitor turns off. MoBo...

I am building a new PC but stuck at power on, Configuration AMD Ryzen 5 4650G ASRock B550M Pro4 MotherBoard Corsair Vengeance LPX 32GB (2 x 16GB) DDR4 DRAM 3600MHz (CMK32GX4M2D3600C18) Antec NeoEco 550M 550W Testing without mounting Motherboard in cabinet, CPU fan runs. No Beep's, No Post, No...

Building a new rig - six years since last time, and a bit rusty! The power turns on fine, but there is no display signal on any of the outputs on either the motherboard or the GPU and the DRAM light on the motherboard is on. I first tried the A2 and B2 slots for the RAM, but to no avail. I...

ASUS ROG Strix B450-F GAMING Hi, just got my pc last week and had an issue where the only thing that received power was the MB. Sp I changed the MB to the b450 and had the fans and everything spin up nicely. Now I have another issue with the dram light blinking and the pc not giving any video...

I have the following situation: I have installed the DDR4 modules according to the installation instructions (DIMMA-2 and DIMMB2), but the equipment does not start me and the EZ Debug indicator shows that it does not advance from the DRAM evaluation, leaving an infinite cycle between CPU and...

My computer was working completely fine I decided to clean my filters and took out my gpu to clean the fans I plugged everything back in and my computer would turn on and turn off again and again I saw that the dram light was on my motherboard so I took my ram out and tried every slot and my...

I went into the UEFI and changed the DRAM frequency from 2400MHz to 2666MHz. This is the model/part number of my RAM sticks: CT8G4DFD824A. The maximum officially rated speed for them is 2400MHz, however both the CPU and motherboard support 2666MHz max. So I adjusted only the DRAM frequency...

Hi All, Due to some instability issues like failure in prime95 tests and random freeze reboots in my pc build which was working fine for the past 1 year, I decided to rule out my RAM by doing a Memtest. I tested them together passed Memtest86 and HCI Memtest with no issues. Then I tested one...

I recently carried out a build with the following components: CPU: AMD Ryzen 7 5800x Mobo: ASUS TUF Gaming x570 Plus wifi PSU: Corsair RM750x 80 PLUS Gold GPU: MSI RTX 3080 Gaming Trio When I hit the power button, there are signs the system is receiving power (e.g. lights and fans turn on)...